INVENTOR CLCO290-09 User Manual

EN
15
|Operation
MODE button
Choose the desired operating mode. By
pressing the MODE button each time
an operation is selected in the following
order: COOL – FAN – DRY. Indication led
will illuminate under the desired MODE
setting.
NOTE: On above modes, the unit operates
the auto fan speed automatically. You
can set fan speed only by the remote
controller on COOL and FAN modes.
Up (+) and Down (-) buttons Are used to
set the temperature in increments of 1ºC
or 2ºF ranging from 17ºC (62ºF) to 30ºC
(86ºF).
NOTE: The remote control may display
the temperature in both Fahrenheit or
Celsius. To change press and hold the up/
down buttons for 3 sec.
Power button
Power switch on/o.
LED display
Shows the set temperature while on cool mode.
While on DRY and FAN modes, it
shows the
room temperature. Shows Error
codes:
E1-Room temperature sensor error.
E2-Evaporator temperature sensor
error.
E4-Display panel communication
error.
EC-Refrigerant leakage detection malfunction
(on some models).
Shows protection code:
P1-Bottom tray is full--Connect the drain hose
and drain the collected water away.If protection
repeats,call for service.
Note: When one of the above malfunctions
occurs, turn o the unit, and check for any
obstructions. Restart the unit, if the malfunction
is still present, turn o the unit and unplug the
power cord. Contact the manufacturer or its
service agents or a similar qualied person for
service.
Exhaust hose installation
The exhaust hose and its adaptor should be
installed or removed according to the usage
mode. Under COOL mode the exhaust hose
must be installed, under FAN or DRY the
exhaust hose should be removed
Operation Instructions
COOL operation
-Press the "MODE" button until the "COOL"
indicator light comes on.
-Press the ADJUST buttons "+" or "-" to
select your desired room temperature. The
temperature can be set within a range of
17°C~30°C/62°F~88°F(or 86°F).
-Press the "FAN SPEED" button on the remote
cotroller to choose the fan speed.
DRY operation
-Press the "MODE" button until the "DRY"
indicator light is active.
-Under DRY mode, the fan speed or adjusting
the temperature is not possible. The fan
operates under low speed.
-For optimal dehumidifying please keep all
windows and exits shut.
-Do not put the duct to window.
FAN operation
-Press the "MODE" button until the"FAN "
indicator light comes on.
-Press the "FAN SPEED" button on the
remote cotrollerto choose the fan speed. The
temperature can not be adjusted.
-Do not put the duct to window.
Power
indicator light
Timer mode
indicator
light (set only by
remote controller)
Power
indicator light
Timer mode
indicator
light (set only by
remote controller)

INVENTOR CLCO290-09 Specifications

General

Brand	INVENTOR
Model	CLCO290-09
Category	Air Conditioner
Language	English