What to do if water is left inside the inventum IVW6012A after the cycle?
If water remains in the Inventum dishwasher after the cycle, it could be due to a clogged or twisted drain hose, clogged filters, or the cycle not being fully completed.
What to do if there are partial food wastes left on the dishes in my inventum IVW6012A?
Partial food waste remaining on dishes in your Inventum dishwasher can occur if: - The dishes are not placed correctly, obstructing the spray arms. - The basket is overloaded. - The dishes lean against each other. - An insufficient amount of detergent is used. - The wrong program is selected. - One of the spray arms is clogged with food waste. - The filters are clogged or incorrectly placed. - The water drain pump is clogged.
How to fix whitish stains on dishes in my inventum IVW6012A?
Whitish stains on dishes from your Inventum dishwasher may be due to: - Using too little detergent. - Low rinse aid dosage. - Not adding special salt despite high water hardness. - Setting an incorrect (too low) water hardness level. - The salt reservoir cap not being closed properly.
How to fix rust stains on dishes in my inventum IVW6012A Dishwasher?
Rust stains on dishes from your Inventum dishwasher might be caused by: - Insufficient stainless steel quality of the dishes. - Too high a dosage of salt. - The salt reservoir cap not being properly closed. - Spilling too much salt inside the dishwasher during refilling. - Polluted water mains.
What to do if the Inventum Dishwasher has inadequate water supply?
If the Inventum dishwasher has an inadequate water supply: - Check if the tap is fully open and that nothing is blocking the water mains. - Close the tap, remove the input hose, and check for clogs. - Restart the dishwasher. If the problem persists, contact Inventum's service department.
Why does my Inventum Dishwasher stop during a wash cycle?
The Inventum dishwasher might stop mid-cycle due to a power failure, water supply failure, or because the program has been paused.
How to fix the inventum IVW6012A Dishwasher that won't dry dishes?
If the Inventum dishwasher isn’t drying dishes properly, it could be because: - A program without a drying process was selected. - The rinse aid dosage is too low. - The dishes are unloaded too quickly.
What to do if the waste water can not be discharged from my inventum IVW6012A?
If the waste water isn’t discharging from the Inventum dishwasher: - Turn off the dishwasher. - Reset the program and check both the filters and the discharge hose for clogs. - Restart the dishwasher. If the issue continues, contact Inventum's service department.
How to fix noise during a wash cycle in my Inventum Dishwasher?
Noise during a wash cycle in the Inventum dishwasher can be caused by: - Improper loading of the dishwasher. - One of the spray arms hitting the dishes.
What does it mean if the indicator lights won’t go off after the cycle has finished on my inventum IVW6012A Dishwasher?
If the indicator lights on the Inventum dishwasher remain on after the cycle, it means that the On/Off button has not been released yet.
General| Type | Freestanding |
|---|---|
| Color | White |
| Number of place settings | 12 |
| Number of programs | 6 |
| Energy efficiency class | A++ |
| Water consumption per cycle | 11 liters |
| Noise level | 49 dB |
| Delay Start | Yes |
| Half Load Option | Yes |
To Next Page