inventum IVW6035AXL User Manual (English)

Questions and Answers:

J
Joy GreenAug 19, 2025
What to do if my Inventum Dishwasher program does not start?
- L
  Linda CrossAug 19, 2025
  If the program on your Inventum Dishwasher isn't starting, check the following: * Ensure the mains plug is properly connected; if not, connect it. * Check the fuse box for any issues and resolve them. * Make sure the water supply is open by opening the water tap. * Verify that the dishwasher door is fully closed; if not, close it. * Confirm that the appliance is switched on. If it is off, start the appliance.
D
Danielle StewartAug 21, 2025
What to do if my inventum IVW6035AXL appliance contains water when the program is finished?
- C
  christopher23Aug 21, 2025
  If water remains in the appliance after the program finishes: * Check the drain hose for clogs or twists and correct them. * Clean the filters if they are clogged. * Wait until the program has fully completed. A buzzer will sound five times, and the ready indicator will light up upon completion.
J
Jenny RobinsonAug 23, 2025
Why is there food waste left on my inventum IVW6035AXL dishes?
- A
  Alexis DayAug 23, 2025
  Food waste may remain on dishes for several reasons: * The appliance might not be loaded correctly, preventing spray arms from reaching all dishes. * The cutlery basket might be too full. * Dishes may be placed too closely together. * The amount of detergent used may be insufficient. * The selected program may not be suitable for the load. * One of the spray arms could be clogged. * The filters might be clogged.
J
Joseph GravesAug 26, 2025
Why are there white stains on my inventum IVW6035AXL dishes?
- A
  Amanda HudsonAug 26, 2025
  White stains on dishes can occur due to several reasons: * Insufficient detergent. * Rinse aid consumption level is set too low. * High water hardness without using salt. * Water hardness level is set too low, affecting salt consumption. * The salt reservoir cap is not closed correctly.
S
Scott BrownAug 27, 2025
What to do if my Inventum Dishwasher leaves dishes not dry?
- J
  Jesse RuizAug 27, 2025
  If your dishes are not drying properly, consider the following: * The selected program may not include a drying cycle. Choose a program that does. * The rinse aid level might be set too low. Adjust it accordingly. * You might be unloading the dishwasher too soon after the cycle finishes. Wait a few minutes before unloading.
J
juan98Aug 29, 2025
Why does my Inventum Dishwasher appliance stop during a program?
- M
  Mr. Kurt Contreras DDSAug 30, 2025
  The appliance might stop mid-cycle due to: * A power failure. Ensure there is a power supply. * A water inlet failure. Ensure there is water inlet supply. * The program being paused. Try starting the program again.
M
Matthew DavisSep 1, 2025
What to do if my inventum IVW6035AXL Dishwasher shows error F5?
- A
  Antonio MartinezSep 1, 2025
  If your Inventum Dishwasher displays error code F5: * Ensure the water tap is fully open and the water supply isn't blocked. * Close the tap, remove the inlet hose, and check for clogs. * Restart the appliance. If the error persists, contact Inventum-servicedienst.
Z
Zachary WeaverSep 3, 2025
What to do if my inventum IVW6035AXL Dishwasher makes unusual sounds during a program?
- V
  Vanessa WoodSep 3, 2025
  Unusual noises during a wash cycle can be caused by: * Incorrect loading of the appliance. Ensure proper loading. * Spray arms hitting the dishes. Ensure proper loading.
S
Stephen LongSep 5, 2025
What to do if my inventum IVW6035AXL Dishwasher shows error F2?
- E
  Erin SchneiderSep 5, 2025
  If your Inventum Dishwasher displays error code F2: * Check the drain hose for clogs. * Check if the filters are clogged. * Switch the appliance off and reset the program. * If the error persists, contact Inventum-servicedienst.
D
Dawn PageSep 7, 2025
What to do if my inventum IVW6035AXL shows error F3?
- J
  Jennifer DavisSep 7, 2025
  If your Inventum Dishwasher displays error code F3: * Close the water tap. * Contact the Inventum-servicedienst.

inventum IVW6035AXL Specifications

General

Type	Freestanding
Appliance placement	Freestanding
Control panel colour	Stainless steel
Capacity	15 place settings
Number of programs	8
Height	85 cm
Width	60 cm
Depth	60 cm
Drying system	Condensation drying
Delayed start timer	Yes
Delayed start	1-24 hours
Drying Class	A
Half Load Option	Yes
Water consumption per cycle	9.5 liters