inventum IVW6006A - User Manual

Questions and Answers

C
Candice BraunAug 13, 2025
Why is there food waste left on my inventum IVW6006A Dishwasher dishes?
- S
  Sarah LongAug 13, 2025
  If your Inventum dishwasher leaves food waste on the dishes, it might be due to several reasons: * The appliance may not be loaded correctly, preventing the spray arms from reaching all dishes. * The cutlery basket might be too full. * Dishes might be placed too close together. * There might be an insufficient amount of detergent. * The selected program may not be suitable for the loaded dishes. * One of the spray arms could be clogged. * The filters might be clogged or not placed correctly. * The water drain pump might be clogged. To resolve this, ensure you load the appliance correctly, use enough detergent, select an appropriate program, and clean the spray arms and filters.
C
christopherstevensAug 16, 2025
What to do if my inventum IVW6006A Dishwasher has white stains on the dishes?
- M
  Mark HendersonAug 16, 2025
  If your Inventum dishwasher has white stains on the dishes, it could be due to: * Insufficient detergent. * The rinse aid consumption level being set too low. * High water hardness without using salt. * The water hardness level being set too low. * The salt reservoir cap not being closed correctly. To fix this, ensure you use enough detergent, adjust the rinse aid level, fill the salt reservoir, adjust the salt consumption level, and ensure the salt reservoir cap is firmly closed.
V
vryanAug 20, 2025
Why does my Inventum Dishwasher still have water after the cycle?
- R
  Raymond McdonaldAug 20, 2025
  If your Inventum Dishwasher contains water after the program finishes, it could be due to: * A clogged or twisted drain hose. To solve this, ensure the drain hose is not clogged or twisted. * Clogged filters. To solve this, clean the filters. * The program not being finished. To solve this, wait until the program is finished. A buzzer sounds five times when the program is finished.
N
nmoranAug 25, 2025
What to do if there is insufficient water supply in my Inventum Dishwasher?
- A
  Abigail LongAug 25, 2025
  • Make sure that the water tap is fully open and that the water supply is not blocked. • Close the water tap, remove the water inlet hose and do a check if the hose is clogged. • Start the appliance again. • Contact the Inventum-servicedienst if the fault code keeps re-occuring.
A
Allison HaynesAug 28, 2025
Why are my dishes not dry after using Inventum Dishwasher?
- R
  Roger WellsAug 28, 2025
  If your Inventum dishwasher isn't drying dishes properly, it might be because: * The selected program does not include drying. * The level of rinse aid consumption is set too low. To resolve this, select a program that includes drying or adjust the level of rinse aid consumption.
C
Chris WilliamsAug 31, 2025
Why are there rust stains on my Inventum Dishwasher dishes?
- J
  John SpencerSep 1, 2025
  If rust stains appear on your dishes after using the Inventum dishwasher, it could be due to: * Insufficient stainless steel quality of the dishes. * The level of salt consumption is set too high. * The cap of the salt reservoir is not closed correctly. * Spilled salt during filling of the salt reservoir was not cleaned immediately. * The water supply is polluted. To resolve this, ensure you only clean dishwasher-safe dishes, adjust the level of salt consumption, make sure that the cap of the salt reservoir is closed firmly, clean any spilled salt immediately and run a full program, and check the water supply.
E
Emily GordonSep 4, 2025
What to do if my inventum IVW6006A Dishwasher stops mid cycle?
- D
  David AustinSep 4, 2025
  If your Inventum dishwasher stops mid-cycle, check if: * There is a power failure. If so, ensure there is power. * There is a water inlet failure. If so, ensure there is a water inlet supply. * The program is paused. If so, start the program.
D
Diana HunterSep 8, 2025
Why is my inventum IVW6006A Dishwasher making unusual sounds?
- A
  Angela Sparks DDSSep 8, 2025
  If your Inventum dishwasher is making unusual noises, it could be because: * The appliance is not loaded correctly. * One of the spray arms is hitting the dishes. To fix this, make sure that you load the appliance correctly.