Why won't my Inventum Dishwasher program start?
If the program on your Inventum Dishwasher won’t start, several factors could be the cause. First, ensure the plug is properly connected and check the fuse in the fuse box. Also, verify that the water tap is open and the dishwasher door is securely closed. Confirm the dishwasher is turned on using the On/Off button and check that the water inlet hose and filters are not clogged.
What to do if my Inventum Dishwasher is not discharging waste water?
If your Inventum Dishwasher isn't discharging waste water, it could be due to a clogged discharge hose or filters. Turn off the dishwasher, reset the program, and then inspect both the filters and the discharge hose for any blockages. You can also restart the dishwasher. If the issue persists, contact the service department of Inventum.
What to do if water is left inside my inventum IVW6033A Dishwasher after cycle?
If water remains in your Inventum Dishwasher after the cycle, the water drain hose or the filters might be clogged or twisted. Alternatively, the cycle might not have finished yet.
Why is there inadequate water supply to my inventum IVW6033A?
If your Inventum Dishwasher isn't getting enough water, make sure the tap is fully open and there are no obstructions in the water mains. Close the tap, disconnect the input hose, and check for clogs. Then, restart the dishwasher. If the problem continues, contact Inventum's service department.
Why are there partial food wastes left on the dishes in my inventum IVW6033A?
Partial food waste remaining on dishes in your Inventum Dishwasher can occur for several reasons: the dishes may not be placed correctly, preventing the spray arms from reaching all surfaces; the basket might be overloaded; dishes may be leaning against each other; too little detergent may have been used; the wrong program may have been selected; one of the spray arms may be clogged with food waste; the filters may be clogged or not correctly placed; or the water drain pump may be clogged.
Why does my Inventum Dishwasher stop during a wash cycle?
Your Inventum Dishwasher might stop mid-cycle due to a power failure, a water supply failure, or because the program has been paused.
How to fix whitish stains on dishes from inventum IVW6033A?
Whitish stains on dishes from your Inventum Dishwasher can be caused by several factors: using too little detergent, insufficient rinse aid dosage, not adding special salt despite high water hardness, setting the water hardness level too low, or failing to close the salt reservoir cap properly.
How to stop water supply when it is not stopping in my Inventum Dishwasher?
If the water supply to your Inventum Dishwasher won't stop, immediately close the tap and contact the service department of Inventum.
Why are my dishes not drying in the Inventum Dishwasher?
Dishes may not dry in your Inventum Dishwasher if a program without a drying process was selected, the rinse aid dosage is too low, or the dishes are unloaded too quickly.
What to do if safety is activated against water overflow in inventum IVW6033A Dishwasher?
If the safety feature against water overflow is activated in your Inventum Dishwasher, turn off the dishwasher and close the tap. Then, contact the service department of Inventum.
General| Type | Freestanding |
|---|---|
| Appliance placement | Freestanding |
| Energy efficiency class | A++ |
| Dimensions (H x W x D) | 82 x 60 x 57 cm |
| Control panel colour | Stainless steel |
| Number of washing programs | 6 |
| Annual energy consumption | 258 kWh |
| Annual water consumption | 2520 liters |
| Width | 60 cm |
| Drying Class | A |
| Delay Start | Yes |
| Child Lock | Yes |
| Weight | 42 kg |
| Water consumption per cycle | 9 L |
| Program options | Eco, Intensive, Quick, Delicate |
| Drying system | Condensation |
| Depth | 60 cm |
| Height | 85 cm |
| Programs | Eco, Intensive, Quick, Delicate |
To Next Page