Why won’t the indicator lights go off on my inventum IVW6013A Dishwasher?
If the indicator lights on your Inventum dishwasher won’t turn off after the cycle finishes, it might be because the On/Off button hasn't been released yet.
What to do if water is left inside the inventum IVW6013A at the end of the cycle?
If water remains in your Inventum Dishwasher after a cycle, it could be due to several reasons. Check the water drain hose to ensure it is not clogged or twisted. Also, inspect the filters for any blockages. It's also possible that the wash cycle hasn't finished yet.
What to do if inventum IVW6013A has partial food wastes left on the dishes?
If your Inventum dishwasher leaves food waste on dishes, it could be due to several issues: * Dishes may not be placed correctly, blocking the spray arms. * The basket might be overloaded. * Dishes may be leaning against each other. * You might not be using enough detergent or have selected the wrong program. * A spray arm, the filters, or the water drain pump could be clogged. * The filters might not be placed correctly.
How to fix inadequate water supply in inventum IVW6013A Dishwasher?
To address an inadequate water supply in your Inventum dishwasher: * Ensure the tap is fully open and that there are no obstructions in the water mains. * Close the tap, disconnect the input hose, and inspect it for clogs. * Restart the dishwasher. If the issue persists, contact Inventum's service department.
How to get rid of whitish stains on dishes in inventum IVW6013A Dishwasher?
Whitish stains on dishes from your Inventum Dishwasher can be caused by: * Insufficient detergent. * Too little rinse aid. * Lack of special salt despite hard water. * Incorrectly set water hardness level. * A loose salt reservoir cap.
How to improve drying in inventum IVW6013A?
If your dishes aren’t drying in the Inventum dishwasher, it could be because a program without a drying process was selected, the rinse aid dosage is too low, or the dishes are unloaded too quickly.
How to remove whitish stains on dishes from inventum IVW6013A?
If you notice whitish stains on the dishes after using your Inventum dishwasher, it may be due to: - Insufficient detergent. - Too little rinse aid. - Lack of special salt despite hard water. - Incorrectly set water hardness level. - A loose salt reservoir cap.
Why does the Inventum dishwasher stop during a wash cycle?
If your Inventum dishwasher stops during a wash cycle, it might be due to a power failure, a water supply failure, or the program being paused.
What to do if indicator lights won’t go off after Inventum Dishwasher cycle?
If the indicator lights on your Inventum Dishwasher remain on after the cycle finishes, it means the On/Off button has not been released yet.
Why Inventum Dishwasher dishes won’t dry?
If your dishes aren't drying in the Inventum Dishwasher, it could be because a program without a drying cycle was selected, the rinse aid dosage is too low, or the dishes are being unloaded too quickly.
General| Type | Freestanding |
|---|---|
| Energy Efficiency Class | A++ |
| Number of Place Settings | 13 |
| Noise Level | 49 dB |
| Water Consumption per Cycle | 9.5 L |
| Number of Programs | 6 |
| Color | White |
| Drying Efficiency Class | A |
| Delay Start | Yes |
| Half Load Option | Yes |
| Dimensions (HxWxD) | 850 x 600 x 600 mm |
To Next Page