What to do if my inventum Dishwasher program won’t start?
If your Inventum dishwasher program isn't starting, begin by verifying that the plug is securely connected and the fuse in the fuse box is intact. Confirm that the water tap is fully open and the dishwasher door is properly closed. Ensure the dishwasher is powered on using the On/Off button. Finally, inspect the water inlet hose and filters for any clogs.
How to fix inadequate water supply in inventum IVW6015A Dishwasher?
If your dishwasher isn't getting enough water, first, check that the tap is fully open and that there are no obstructions in the water mains. Next, close the tap, detach the input hose, and inspect it for any clogs. Restart the dishwasher after these checks. If the issue continues, contact Inventum's service department.
Why is water left inside inventum IVW6015A Dishwasher after cycle?
If water remains in your Inventum dishwasher after the cycle, the water drain hose might be clogged or twisted, or the filters could be clogged. It's also possible that the cycle hasn't fully completed.
What to do if inventum IVW6015A Dishwasher water supply is not stopping?
To address a water supply that won't stop, close the tap and contact Inventum's service department.
Why are there food wastes left on my inventum IVW6015A dishes?
If you notice food waste remaining on your dishes after a wash cycle, several factors could be at play. Ensure dishes are correctly placed to allow the spray arms to reach all surfaces, and avoid overloading the basket or letting dishes lean against each other. Verify that you're using enough detergent and selecting the appropriate program for the load. Also, check if any of the spray arms are clogged with food waste, or if the filters are clogged or incorrectly placed. Finally, a clogged water drain pump could also be the cause.
Why won't my inventum IVW6015A Dishwasher dry the dishes?
If your dishes aren't drying properly, it could be due to a few reasons. Check if you selected a program that includes a drying process. The rinse aid dosage might also be too low. Also, avoid unloading the dishes too quickly after the cycle finishes.
What to do if inventum Dishwasher waste water can not be discharged?
If your dishwasher isn't discharging waste water, it may be due to a clogged water discharge hose or clogged filters. To resolve this, turn off the dishwasher, reset its program, and inspect both the filters and the discharge hose. Then, restart the dishwasher. If the issue persists, contact Inventum's service department.
Why do I hear noise during inventum IVW6015A wash cycle?
If you hear unusual noises during a wash cycle, it could be due to improper loading of the dishwasher or a spray arm hitting the dishes.
Why does my inventum Dishwasher stop during wash cycle?
Your Inventum dishwasher might stop mid-cycle because of a power failure, a water supply failure, or because the program has been paused.
Why are there rust stains on my inventum Dishwasher dishes?
Rust stains on dishes can be caused by insufficient stainless steel quality of the dishes themselves, too high a dosage of salt, a salt reservoir cap that isn't closed properly, salt spillage inside the dishwasher during refilling, or polluted water mains.
General| Type | Freestanding |
|---|---|
| Colour | White |
| Number of place settings | 15 |
| Energy Efficiency Class | A++ |
| Delay Start | Yes |
| Half Load Option | Yes |
| Dimensions (H x W x D) | 85 x 60 x 60 cm |
To Next Page
