What to do if indicator lights won’t go off after Inventum Dishwasher cycle?
If the indicator lights on your Inventum Dishwasher remain on after the cycle finishes, it means the On/Off button has not been released yet.
Why won't my inventum IVW6013A program start?
If your Inventum Dishwasher program won’t start, there are several things to check: * Ensure the dishwasher is properly plugged in. * Check the fuse in the fuse box. * Make sure the water tap is open. * Confirm that the dishwasher door is completely closed. * Verify the dishwasher is turned on using the On/Off button. * Inspect the water inlet hose and filters to ensure they are not clogged.
Why Inventum Dishwasher dishes won’t dry?
If your dishes aren't drying in the Inventum Dishwasher, it could be because a program without a drying cycle was selected, the rinse aid dosage is too low, or the dishes are being unloaded too quickly.
How to fix the inventum IVW6013A Dishwasher when the waste water can not be discharged?
If the waste water isn't discharging from your Inventum dishwasher, turn it off. Reset the program and inspect both the filters and the discharge hose for clogs. Then, restart the dishwasher. The issue may be that the water discharge hose is clogged, or the filters might be clogged.
Why inventum IVW6013A Dishwasher water supply is not stopping?
If the water supply to your Inventum Dishwasher isn't stopping, immediately close the tap. After that, contact the Inventum service department.
Why does my inventum IVW6013A stop during a wash cycle?
Your Inventum Dishwasher might stop mid-cycle due to a power failure, so check the power supply. It could also be due to a water supply failure, so check the water supply. Also, the program may have been paused.
How to fix rust stains on dishes in inventum IVW6013A?
Rust stains on dishes washed in your Inventum Dishwasher may be due to: * The stainless steel quality of the dishes is insufficient. * Too much salt is being used. * The salt reservoir cap isn't closed properly. * Salt spillage occurred while refilling the reservoir. * The water mains are polluted.
How to get rid of whitish stains on dishes in inventum IVW6013A Dishwasher?
Whitish stains on dishes from your Inventum Dishwasher can be caused by: * Insufficient detergent. * Too little rinse aid. * Lack of special salt despite hard water. * Incorrectly set water hardness level. * A loose salt reservoir cap.
How to fix inadequate water supply in inventum IVW6013A Dishwasher?
To address an inadequate water supply in your Inventum dishwasher: * Ensure the tap is fully open and that there are no obstructions in the water mains. * Close the tap, disconnect the input hose, and inspect it for clogs. * Restart the dishwasher. If the issue persists, contact Inventum's service department.
What to do if inventum IVW6013A has partial food wastes left on the dishes?
If your Inventum dishwasher leaves food waste on dishes, it could be due to several issues: * Dishes may not be placed correctly, blocking the spray arms. * The basket might be overloaded. * Dishes may be leaning against each other. * You might not be using enough detergent or have selected the wrong program. * A spray arm, the filters, or the water drain pump could be clogged. * The filters might not be placed correctly.
General| Type | Freestanding |
|---|---|
| Energy Efficiency Class | A++ |
| Number of Place Settings | 13 |
| Noise Level | 49 dB |
| Water Consumption per Cycle | 9.5 L |
| Number of Programs | 6 |
| Color | White |
| Drying Efficiency Class | A |
| Delay Start | Yes |
| Half Load Option | Yes |
| Dimensions (HxWxD) | 850 x 600 x 600 mm |
To Next Page