inventum VVW6035AS - User Manual

Questions and Answers

J
jasmin26Aug 18, 2025
What to do if the inventum VVW6035AS Dishwasher program does not start?
- E
  Eric WardAug 18, 2025
  If the program on your Inventum Dishwasher doesn't start, several factors could be the cause. First, ensure the mains plug is properly connected. Check your fuse box for any issues. Verify that the water tap is open to provide a water supply. Make sure the dishwasher door is fully closed and that the appliance is switched on. Also, check that the water inlet hose and filters are not clogged.
K
Kristy AndersonAug 20, 2025
Why is there food waste left on the dishes in my Inventum Dishwasher?
- K
  Kenneth MarshallAug 20, 2025
  If you find food waste on your dishes after running your Inventum Dishwasher, it could be due to several reasons: * The appliance might not be loaded correctly, preventing the spray arms from reaching all dishes. * The amount of detergent used may be insufficient. * The selected program may not be suitable for the type of dishes loaded. * One of the spray arms or the filters could be clogged. * The filters might not be placed correctly or the water drain pump could be clogged. Ensure that you load the appliance correctly, use a sufficient amount of detergent, select an appropriate program, and that all components are clean and correctly placed.
T
Travis JenkinsAug 22, 2025
What to do if the Inventum Dishwasher contains water when the program is finished?
- Y
  ylamAug 22, 2025
  If your Inventum Dishwasher still contains water after the program finishes, there are a few things to check. First, ensure that the drain hose is not clogged or twisted. Also, the filters may be clogged, so inspect and clean them if necessary. Finally, make sure the program has actually completed; a buzzer will sound five times, and the ready indicator will light up when it's done.
L
Luis MoranAug 26, 2025
How to fix white stains on dishes from Inventum Dishwasher?
- L
  Lydia JacobsonAug 26, 2025
  White stains on dishes from your Inventum Dishwasher can occur for several reasons. You may not be using enough detergent. The rinse aid consumption level might be set too low. If you have hard water, the salt reservoir may need to be filled. Also, ensure that the cap of the salt reservoir is closed tightly.
A
April RivasAug 27, 2025
Why are the dishes not dry after using inventum VVW6035AS?
- T
  tiffanypetersAug 27, 2025
  If your dishes aren't drying in your Inventum Dishwasher, it could be because the selected program doesn't include a drying cycle, so choose a program that does. Alternatively, the level of rinse aid consumption might be set too low; in that case, adjust it accordingly.
M
Michael LewisAug 30, 2025
What to do if Inventum Dishwasher stops during a program?
- A
  Alejandra SimpsonAug 30, 2025
  If your Inventum Dishwasher stops mid-cycle, first check for a power failure. Also, ensure that there is an adequate water inlet supply.
D
David MyersSep 1, 2025
How to fix rust stains on dishes in my Inventum Dishwasher?
- C
  Cynthia DennisSep 1, 2025
  Rust stains on dishes washed in your Inventum Dishwasher may be due to several factors. The stainless steel quality of your dishes might be insufficient, so ensure you are only washing dishwasher-safe items. There could be a high level of salt in the water, or the salt reservoir cap may not be closed correctly. Also, spilled salt during filling of the reservoir may not have been cleaned immediately. Make sure to clean any spilled salt and run a full program to prevent corrosion.
S
shane74Sep 4, 2025
What causes unusual sounds during an inventum VVW6035AS program?
- J
  Jessica HowardSep 4, 2025
  Unusual sounds during an Inventum Dishwasher program can occur if one of the spray arms is hitting the dishes. Make sure that you load the appliance correctly.
C
Christine JonesSep 7, 2025
What does F5 error mean on Inventum Dishwasher?
- T
  Timothy HamiltonSep 7, 2025
  The F5 error code on your Inventum Dishwasher indicates an insufficient water supply. Ensure the water tap is fully open and the water supply isn't blocked. Close the tap, remove the inlet hose, and clean the hose filter.
W
William DixonSep 9, 2025
What does F2 error mean on Inventum Dishwasher?
- M
  Michael GonzalezSep 9, 2025
  The F2 error on your Inventum Dishwasher means that the waste water in the appliance cannot be discharged. Check if the drain hose or the filters are clogged. You can also try resetting the program.

inventum VVW6035AS Specifications

General

Type	Freestanding
Place settings	13
Noise level	49 dB
Number of programs	6
Energy efficiency class	A++
Capacity	13 place settings
Delay start	Yes
Child lock	Yes
Dimensions (HxWxD)	85 x 60 x 60 cm