Why won't the inventum VVW6022A Dishwasher program start?
If the Inventum dishwasher program won’t start: * Ensure the plug is correctly connected. * Check the fuse in the fuse box. * Verify the water tap is open. * Confirm the dishwasher door is properly closed. * Ensure the dishwasher is turned on. * Check that the water inlet hose and filters are not clogged.
What to do if I have inadequate water supply in my Inventum Dishwasher?
If you're experiencing an inadequate water supply, check if the tap is fully open and that there are no blockages in the water mains. Also, close the tap, remove the input hose, and inspect it for any clogs. After checking these, start the dishwasher again. If the issue continues, additional support is needed.
How to fix inadequate water supply in inventum VVW6022A Dishwasher?
To resolve an inadequate water supply in your Inventum dishwasher: * Ensure the tap is fully open and there are no obstructions in the water mains. * Close the tap, detach the input hose, and inspect for clogs. * Restart the dishwasher. If the issue persists, contact Inventum's service department.
Why is water left inside the Inventum Dishwasher after cycle?
If water is left inside the Inventum dishwasher at the end of the cycle, it could be due to a clogged or twisted water drain hose, clogged filters, or the cycle not being completed yet.
What to do if the waste water can not be discharged from my inventum VVW6022A Dishwasher?
If the waste water isn't being discharged, the water discharge hose or the filters might be clogged. Turn off the dishwasher, reset the program, and then check both the filters and the discharge hose. After checking, restart the dishwasher. If the problem persists, further assistance is needed.
What to do if safety is activated against water overflow in my Inventum Dishwasher?
If the safety feature against water overflow is activated, turn off the dishwasher and close the tap. Additional support is needed.
What to do if the waste water can not be discharged from Inventum Dishwasher?
If the waste water cannot be discharged from your Inventum dishwasher, it might be due to a clogged water discharge hose or clogged filters. Turn off the dishwasher, reset the program, and then check both the filters and the discharge hose. If the error persists, restart the dishwasher. If the issue still remains, contact the Inventum service department.
Why does the Inventum Dishwasher stop during a wash cycle?
If the Inventum dishwasher stops during a wash cycle, this could be due to a power failure, a water supply failure, or because the program has been paused.
Why are there partial food wastes left on the dishes in my inventum VVW6022A?
If you observe partial food wastes left on the dishes in your Inventum dishwasher, it could be due to several reasons: * Dishes aren’t placed correctly, preventing spray arms from reaching everything. * The basket is overloaded. * Dishes lean against each other. * Too small amount of detergent is added. * Wrong program selected. * One of the spray arms is clogged with food waste. * The filters are clogged or not placed correctly. * The water drain pump is clogged.
Why do I hear noise during a wash cycle in my Inventum Dishwasher?
If you hear noise during a wash cycle in your Inventum dishwasher, it may be because the dishwasher is not loaded properly or one of the spray arms is hitting the dishes.
General| Type | Freestanding |
|---|---|
| Place settings | 12 |
| Noise level | 49 dB |
| Number of programs | 6 |
| Energy efficiency class | E |
| Number of Place Settings | 12 |
| Annual Energy Consumption | 258 kWh |
| Delay Start | Yes |
| Half Load Option | Yes |
| Dimensions (H x W x D) | 84.5 x 59.8 x 60 cm |
| Weight | 47 kg |
| Programs | Eco, Glass, Intensive |
To Next Page