inventum VVW6024A - User Manual

inventum VVW6024A

56 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

vrijstaande vaatwassers

DISHWASHER

VVW6022A

VVW6024A

VVW6026A

• gebruiksaanwijzing

• instruction manual

VVW60 - instructions 1214.indd 1 1-12-2014 15:20:18

Table of Contents

Questions and Answers

T
Tricia MartinezAug 20, 2025
What to do if my inventum VVW6024A Dishwasher program won’t start?
- M
  Molly RothAug 20, 2025
  If the program on your Inventum dishwasher isn't starting, please check the following: - Ensure the dishwasher is properly connected to a power outlet. - Verify the fuse in the fuse box is functional. - Confirm the water tap is fully open. - Ensure the dishwasher door is securely closed. - Check that the dishwasher is turned on using the On/Off button. - Inspect the water inlet hose and filters to make sure they are not clogged.
K
Kathy McleanAug 22, 2025
What to do if I have inadequate water supply in my Inventum Dishwasher?
- C
  colleen14Aug 22, 2025
  If you're experiencing an inadequate water supply, check if the tap is fully open and that there are no blockages in the water mains. Also, close the tap, remove the input hose, and inspect it for any clogs. After checking these, start the dishwasher again. If the issue continues, additional support is needed.
S
Shirley SmithAug 25, 2025
How to fix whitish stains on dishes from my inventum VVW6024A Dishwasher?
- J
  Jennifer AndersonAug 25, 2025
  Whitish stains on dishes from your Inventum dishwasher may occur due to: - Using too little detergent. - The rinse aid dosage being too low. - Not adding special salt despite high water hardness. - Setting the water hardness level too low. - The salt reservoir cap not being closed properly.
B
Beverly WilliamsAug 27, 2025
What to do if my Inventum Dishwasher has an inadequate water supply?
- C
  charlesjustinAug 27, 2025
  If your Inventum dishwasher isn't getting enough water: - Check that the tap is fully open and the water mains aren't blocked. - Close the tap, detach the input hose, and inspect it for clogs. - Restart the dishwasher. If the problem persists, contact Inventum's service department.
P
pamelawhiteAug 28, 2025
What to do if the waste water can not be discharged from my Inventum Dishwasher?
- M
  Michael JohnsonAug 28, 2025
  If the waste water isn't being discharged, the water discharge hose or the filters might be clogged. Turn off the dishwasher, reset the program, and then check both the filters and the discharge hose. After checking, restart the dishwasher. If the problem persists, further assistance is needed.
J
julie44Aug 30, 2025
What to do if safety is activated against water overflow in my inventum VVW6024A?
- B
  Brittany LeeAug 30, 2025
  If the safety feature against water overflow is activated, turn off the dishwasher and close the tap. Additional support is needed.
F
fhallSep 1, 2025
Why are there partial food wastes left on the dishes in my Inventum Dishwasher?
- M
  Melissa AndersonSep 1, 2025
  If you find partial food waste remaining on dishes after a wash cycle in your Inventum dishwasher, consider the following possible causes: - Dishes may not be placed correctly, preventing spray arms from reaching all surfaces. - The basket might be overloaded. - Dishes may be leaning against each other. - An insufficient amount of detergent may have been used. - The wrong program may have been selected. - One of the spray arms could be clogged with food waste. - The filters may be clogged or not placed correctly. - The water drain pump might be clogged.
K
Kathryn KnightSep 3, 2025
Why does my inventum VVW6024A stop during a wash cycle?
- T
  Thomas WilsonSep 3, 2025
  Your Inventum dishwasher might halt mid-cycle due to a power failure or a water supply failure. The program can also be paused.
C
Chase Jackson DDSSep 5, 2025
How to solve rust stains on dishes in inventum VVW6024A?
- J
  Jennifer LambertSep 5, 2025
  Rust stains on dishes washed in your Inventum dishwasher may be caused by: - Insufficient stainless steel quality of the dishes. - Too high a dosage of salt. - The salt reservoir cap not being properly closed. - Spillage of too much salt inside the dishwasher during refilling. - Polluted water mains.
C
codylindseySep 7, 2025
How to improve drying in my inventum VVW6024A?
- L
  laurenwalkerSep 7, 2025
  If your dishes aren’t drying well in your Inventum dishwasher: - Ensure that you have selected a program that includes a drying process. - Check that the rinse aid dosage is adequate. - Avoid unloading the dishes too quickly after the cycle finishes.

inventum VVW6024A Specifications

General

Control panel colour	Black
Built-in display	Yes
Inlet hose length	1.5 m
Outlet hose length	1.5 m
Delayed start timer	Yes
Delay start (max)	24 h
AquaStop function	Yes
Child lock	Yes
Water consumption per cycle	9.5 L
Power consumption (off)	0.5 W
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Washing programs	Eco, Intensive, Quick, Glass
Width	60 cm

Related product manuals

Preview: inventum VVW6022A

inventum VVW6022A

Preview: inventum VVW6025A

inventum VVW6025A

Preview: inventum VVW6023AS

inventum VVW6023AS

Preview: inventum VVW6030AW

inventum VVW6030AW

Preview: inventum VVW6040AB

inventum VVW6040AB

Preview: inventum VVW6035AS

inventum VVW6035AS

Preview: inventum VVW6035AW

inventum VVW6035AW

Preview: inventum VVW6008AW

inventum VVW6008AW

Preview: inventum VVW6030AS

inventum VVW6030AS

Preview: inventum VVW5520

inventum VVW5520

Preview: inventum VVW4530AW

inventum VVW4530AW

Preview: inventum VVW4523AW

inventum VVW4523AW