inventum VVW6040AB User Manual (English)

Questions and Answers:

J
josephbrownAug 21, 2025
Why won't my inventum VVW6040AB Dishwasher program start?
- J
  jonesdeborahAug 21, 2025
  The program might not start due to several reasons: * The mains plug may not be connected; in this case, connect the mains plug. * There might be a problem with the fuse; check the fuse box. * There could be no water supply; open the water tap. * The door of the appliance might be open; close the door. * The appliance might be switched off; start the appliance. * The water inlet hose and filters might be clogged; ensure they are not clogged.
S
Sarah WhiteAug 22, 2025
What to do if there is insufficient water supply in my inventum VVW6040AB?
- J
  Jacqueline GibbsAug 23, 2025
  • Make sure that the water tap is fully open and that the water supply is not blocked. • Close the water tap, remove the water inlet hose and clean the filter of the hose. • Contact the Inventum-servicedienst if the fault code keeps re-occuring.
M
mary57Aug 25, 2025
What to do if my inventum VVW6040AB leaves food waste on the dishes?
- T
  tanya54Aug 25, 2025
  If there is food waste left on the dishes, it could be due to: * Incorrect loading of the appliance, preventing the spray arms from reaching all dishes. Make sure that you load the appliance correctly. * Insufficient detergent. Ensure you fill the detergent reservoir with a sufficient amount of detergent. * An unsuitable program selection for the dishes loaded. Choose a suitable program.
N
Nicholas SweeneyAug 27, 2025
Why are my dishes not drying in my Inventum Dishwasher?
- R
  Robert GrayAug 27, 2025
  If the dishes are not dry, it could be because: * The selected program does not include drying. Choose a program that includes drying. * The level of rinse aid consumption is set too low. Adjust the level of rinse aid consumption.
R
robinsonphyllisAug 28, 2025
Why does my inventum VVW6040AB contain water after the program finishes?
- Z
  Zachary MurphyAug 28, 2025
  If the appliance contains water after the program is finished, check the following: * Ensure the drain hose is not clogged or twisted. Make sure that the drain hose is not clogged and not twisted. * Clean the filters, as they may be clogged. * Wait until the program is finished. A buzzer sounds five times and the ready indicator is on when a program is finished.
H
henry05Aug 29, 2025
Why does my inventum VVW6040AB stop mid-cycle?
- C
  Colton WilliamsAug 29, 2025
  The appliance might stop during a program due to: * A power failure. Make sure that there is power. * A water inlet failure. Make sure that there is water inlet supply.
N
Nicole ConwayAug 31, 2025
What causes white stains on dishes in my Inventum Dishwasher?
- W
  Wendy LeeAug 31, 2025
  White stains on the dishes can occur if: * The amount of detergent is insufficient. Make sure that you fill the detergent reservoir with a sufficient amount of detergent. * The level of rinse aid consumption is set too low. Adjust the level of rinse aid consumption. * There is a high level of water hardness and no salt is used. Fill the salt reservoir. * The cap of the salt reservoir is not closed correctly. Make sure that the cap of the salt reservoir is closed firmly.
U
urichSep 2, 2025
What causes rust stains on dishes in my inventum VVW6040AB Dishwasher?
- C
  Crystal StewartSep 2, 2025
  Rust stains on dishes may appear due to: * Insufficient stainless steel quality of the dishes. Make sure that you only clean dishwasher-safe dishes in the appliance. * A high level of salt in the water. Adjust the level of salt consumption. * The cap of the salt reservoir not being closed correctly. Ensure the cap of the salt reservoir is closed firmly. * Spilled salt during filling of the salt reservoir not being cleaned immediately. Make sure that you clean any spilled salt immediately and run a full program to prevent corrosion. * A problem with the grounding of the mains supply. Contact an authorized electrician.
C
Carlos GarnerSep 4, 2025
Why is my inventum VVW6040AB making unusual sounds?
- C
  christopherabbottSep 4, 2025
  The appliance may make unusual sounds during a program if one of the spray arms hits the dishes. Make sure that you load the appliance correctly.
R
Robin CortezSep 5, 2025
What to do if the water supply does not stop in Inventum Dishwasher?
- J
  Julian GraySep 6, 2025
  • Close the water tap. • Contact the Inventum-servicedienst.