Need help?Do you have a question about the INVT GD100-0R7G-4-PV and is the answer not in the manual?
General| Model | GD100-0R7G-4-PV |
|---|---|
| Type | Solar Pump Inverter |
| Rated Output Power | 0.75kW |
| Max Efficiency | 98% |
| MPPT Efficiency | 99% |
| Protection Class | IP20 |
| Cooling Method | Natural Cooling |
| Communication Interface | RS485 |
| Frequency Range | 50 Hz / 60 Hz |
| Operating Temperature | -10°C to +50°C |
| Storage Temperature | -20°C to +60°C |
| Humidity | 5% to 95%, non-condensing |
Defines terms like Danger, Warning, Note, and Qualified electricians for safety understanding.
Explains standard safety symbols used in the manual for hazard identification and risk avoidance.
Provides essential safety rules for VFD operation, installation, maintenance, and disposal.
Lists the technical specifications and voltage/frequency ratings for different VFD models.
Covers environmental requirements, installation site, and physical mounting of the VFD.
Explains the procedures for connecting power and control circuits to the VFD terminals.
Lists essential checks to perform before powering on the VFD to ensure safety and correct setup.
Guides through the initial trial run process to verify pump operation and performance after installation.
Explains how to enter parameter setting mode and adjust VFD configurations.
Details common VFD parameters for solar pumping applications, including speed control and run command channels.
Provides a comprehensive table of fault codes, possible causes, and recommended solutions for troubleshooting VFD issues.
To Next Page
