Need help?Do you have a question about the INVT GD100-5R5G-4-PV and is the answer not in the manual?
General| Rated Power | 5.5 kW |
|---|---|
| Model | GD100-5R5G-4-PV |
| Output Current | 13 A |
| Protection Level | IP20 |
| Cooling Method | Forced Air Cooling |
| Communication Interface | RS485 |
| Applicable Motor Power | 5.5 kW |
| Carrier Frequency | 1.0kHz - 15.0kHz |
Defines 'Danger', 'Warning', and 'Note' terms used in safety instructions.
Lists and explains safety symbols, their names, and instructions for safe operation.
Provides instructions for connecting main circuit terminals and control circuit terminals.
Essential checks required before powering on the VFD for the first time.
Overview of key parameters for solar pumping applications, including speed control and run command.
Settings for motor characteristics like type, power, frequency, and voltage.
Parameters for V/F curve settings, torque boost, and voltage points for motor control.
Extensive settings for PV input, MPPT, voltage references, and water level control.
PI control parameters, switching points, and water level control settings.
Underload detection, weak light alarms, and delay times for various operational states.
Settings for voltage references, MPPT tracking, and PV input switching.
Table detailing fault codes, possible causes, and recommended solutions for troubleshooting.
To Next Page
