Need help?Do you have a question about the INVT GD200-090G/110P-4 and is the answer not in the manual?
General| Model | GD200-090G/110P-4 |
|---|---|
| Type | Inverter |
| Cooling Method | Forced air cooling |
| Protection Level | IP20 |
| Control Method | Vector Control / V/F Control |
| Frequency Range | 0~400 Hz |
| Efficiency | 98% |
| Input Voltage | 3-phase, 380V-480V |
| Output Voltage | 3 phase 0~rated input voltage |
General rules for safe operation and handling of the inverter.
Safety precautions for delivery and installation procedures.
Safety guidelines for commissioning and operational phases.
Safety measures for maintenance and component replacement.
Essential steps for initial setup and configuration before operation.
Detailed electrical and technical specifications of the inverter.
Table of various operational parameters and ratings.
Guidelines for physical installation of the inverter.
Diagrams and instructions for connecting power and control circuits.
Main circuit wiring schematics for different power ranges.
Visual identification of main circuit terminals across various models.
Step-by-step guide for wiring main circuit terminals.
Schematic for connecting the control circuit wiring.
Identification and description of control circuit terminals.
Measures to protect the inverter and cables from electrical issues.
Protection against short circuits for power cables.
Protection measures for motor and its cable.
General instructions for operating the inverter via the keypad.
Step-by-step guide to changing inverter function codes.
Procedure for setting and managing the inverter's password.
Detailed description of all function parameter groups and their meanings.
Step-by-step guide for the initial power-up procedure.
Explanation of vector control principles and application.
How to use and configure torque control mode.
Setting and autotuning motor parameters for optimal performance.
Configuration options for inverter start-up and stop sequences.
Methods for setting the inverter's operating frequency.
Using the built-in Simple PLC for automated sequences.
Setting up multi-step speed profiles for automated operation.
Configuration and adjustment of PID control loops.
Steps for troubleshooting and resolving inverter faults.
Methods for resetting inverter faults and alarms.
Detailed guidance on diagnosing and resolving specific fault conditions.
General troubleshooting guide for common inverter issues.
Troubleshooting steps when the motor fails to operate.
Diagnosing and resolving motor vibration issues.
Causes and solutions for overvoltage faults.
Troubleshooting steps for undervoltage conditions.
Identifying and resolving inverter overheating issues.
Troubleshooting motor stalls during acceleration.
Identifying and resolving overcurrent faults.
Illustrates RTU command formats and data structures.
Rules for defining data addresses in communication.
How function codes are mapped to parameter addresses.
Codes and meanings for communication fault responses.
Practical examples of read and write commands.
Specifies inverter sizing based on motor current and power.
To Next Page