Need help?Do you have a question about the INVT GD300L Series and is the answer not in the manual?
General| Storage Temperature | -20°C ~ +60°C |
|---|---|
| Output Voltage | 0 ~ Input Voltage |
| Output Power | 0.75kW~630kW |
| Efficiency | ≥98% |
| Cooling Method | Forced air cooling |
| Protection Level | IP20 |
| Communication Protocol | Modbus, CANopen, PROFIBUS |
| Control Mode | V/F control |
| Overload Capacity | 150% for 60s |
| Braking | Built-in braking unit or external braking resistor |
| Protection Features | Overvoltage, undervoltage, overcurrent, short circuit, overheating, phase loss |
| Humidity | 5%~95% (non-condensing) |
| Altitude | ≤1000m (derating above 1000m) |
| Ambient Temperature | -10°C ~ +50°C (derating above 40°C) |
Outlines the essential steps for initial setup and commissioning of the inverter.
Covers mechanical installation requirements and environmental conditions for the inverter.
Details the connections for the main power input and output terminals.
Explains the wiring diagrams and terminal connections for the control circuit.
Covers methods for protecting the inverter and cables from short circuits and overloads.
Explains how to modify function codes and set up password protection.
Details parameters for serial/CAN communication and protective functions.
Covers autotuning, S-curve adjustment, and comfortability settings.
Explains how to identify, reset, and view fault history.
Lists common inverter faults, their possible causes, and recommended solutions.
Provides troubleshooting flowcharts for common issues like motor problems and overvoltage.
Details the Safe Torque Off (STO) function, its logic, and installation checklist.
To Next Page