Goodrive300-LIFT series inverter Safety precautions
-4-
1.4.3 Component maintenance and replacement
Only trained and qualified electricians are allowed to maintain, check, and
replace components of the inverter.
Before wiring the terminals of the inverter, disconnect all power supplies
applied to it and wait for at least the waiting time specified on it.
During the maintenance and replacement of components, take measures to
prevent screws, cables, and other conductive items from dropping into the
inverter.
Note:
Tighten the screws with proper torque.
During the maintenance and replacement of components, prevent the inverter and its
components from coming into contact with or being attached with inflammables.
Do not perform any insulation or withstand voltage tests on the inverter. Do not use a megameter
to measure the control circuit of the inverter.
During the maintenance and replacement of components, take measurements to prevent
electrostatic discharge for the inverter and its internal components.
1.4.4 What to do after scrapping
There are heavy metals in the inverter. Deal with it as industrial effluent.
When the life cycle ends, the inverter should enter the recycling system.
Dispose of it separately at an appropriate collection point instead of
placing it in the normal waste stream.
To Next Page
Loading...
Need help?
General