Goodrive200 inverters Function codes
125
Function
code
Name
Detailed instruction of parameters
Default
value
P13.13
Braking
current of
short-circui
t
When P01.00=0 during the starting of the
inverter, set P13.14 to a non-zero value to enter
the short circuit braking.
When the running frequency is lower than P01.09
during the stopping of the inverter, set 13.15 to a
non-zero value to enter into stopping short
circuited braking and then carry out the DC
braking at the time set by P01.12 (refer to the
instruction of P01.09~P01.12) .
Setting range of P13.13: 0.0~150.0%
(the inverter)
Setting range of P13.14: 0.00~50.00s
Setting range of P13.15: 0.00~50.00s
0.0% ○
P13.14
Braking
retention
0.00s ○
P13.15
The
braking
retention
0.00s ○
P14 Group Serial communication
P14.00
Local
communic
ation
address
The setting range:1~247
When the master is writing the frame, the
communication address of the slave is set to 0;
the broadcast address is the communication
address. All slaves on the MODBUS fieldbus can
receive the frame, but the salve doesn’t answer.
The communication address of the drive is
unique in the communication net. This is the
fundamental for the point to point communication
between the upper monitor and the drive.
Note: The address of the slave cannot set to 0.
Communic Set the digital transmission speed between the 4 ○
To Next Page
Loading...
