INVT GD200-090G/110P-4 - Page 173

Goodrive200 inverters Basic operation instruction
172
Set
value
Function Instructions
come back to the value after the frequency increasing
or decreasing.
34 DC braking
The inverter will begin DC braking after the valid
command.
35 Reserved
36
Shift the command to the
keypad
After the function terminal become valid, the running
command channel will be shifted into keypad running
command channel and the running command channel
will come back to the original state if the function
terminal is invalid.
37
Shift the command to the
terminals
After the function terminal become valid, the running
command channel will be shifted into terminal running
command channel and the running command channel
will come back to the original state if the function
terminal is invalid.
38
Shift the command to the
communication
After the function terminal become valid, the running
command channel will be shifted into communication
running command channel and the running command
channel will come back to the original state if the
function terminal is invalid.
39 Pre-exciting command The function is started if the command is valid
40 Power consumption clear
The power consumption will be cleared after the
command is valid.
41 Power consumption retention
If the command is valid, the current running of the
inverter will not affect its power consumption.
42~60
Reversed
61 PID pole switching
Switch the output pole of PID and be used with
P09.03
62~63
Reversed
Relative parameters list: