25: PID control pause
26: Traverse pause (stop at the current
frequency)
27: Traverse reset (return to the center
frequency)
28: Counter reset
29: Torque control prohibition
30: ACC/DEC prohibition
31: Counter trigger
32: Reserved
33: Cancel the frequency change setting
34: DC brake
35: Reserved
36: Shift the command to the keypad
37: Shift the command to terminals
38: Shift the command to communication
39: Pre-magnetized command
40: Clear the power
41: Keep the power
42: Forced switch to power frequency
input (Switching-on indicates switching to
power frequency input; switching-off
indicates the input mode is controlled by
the keypad.)
43: Full water signal
44: Non-water signal
45: Two-phase control mode of the
single-phase motor
To Next Page
Loading...
