INVT Goodrive300 Series User Manual

Goodrive300 Series VFD Extension card
238
EC-TX-103 communication cards). In order to use PROFIBUS/CANOPEN control VFD, the
communication module must be set to be VFD controller.
Actual value: Actual value is a 16-bit word, which contains converter operation information. Monitoring
capabilities are defined by VFD parameter. The integer scaling of actual value is sent to master
machine depending on selected function, please refer to VFD manual.
Note: VFD always check the control word (CW) and bytes of given value.
Mission message (From master station to VFD)
Control word (CW): The first word of PZD is control word (CW) of VFD. The definitions of CWs on the
PWM rectifier regenerative part are different from those on the inverter part, and therefore two tables
are used to describe the CWs.
Control word (CW) of Goodrive300 series
Bit
Name
Value
State/Description
0–7
COMMAND BYTE
1
Forward running
2
Reverse running
3
Forward jogging
4
Reverse jogging
5
Decelerate to stop
6
Coast to stop (Emergency stop)
7
Fault reset
8
Jogging stop
8
WIRTE ENABLE
1
Write enable (mainly is PKW1-PKW4 )
9–10
MOTOR GROUP SELECTION
00
MOTOR GROUP 1 SELECTION
01
MOTOR GROUP 2 SELECTION
02
MOTOR GROUP 3 SELECTION
03
MOTOR GROUP 4 SELECTION
11
TORQUE CONTROL
SELECTION
1
Torque control enable
0
Torque control disable
12
ELECTRIC CONSUMPTION
CLEAR
1
Electric consumption clear enable
0
Electric consumption clear disable
13
PRE-EXCIATION
1
Pre-exciation enable
0
Pre-exciation disable
14
DC BRAKE
1
DC braking enable
0
DC braking disable
15
HEARTBEAT REF
1
Heartbeat enable
0
Heartbeat disable

INVT Goodrive300 Series Specifications

General

Brand	INVT
Model	Goodrive300 Series
Category	DC Drives
Language	English