INVT iMars BG12KTR

iMars grid-tied solar inverters Safety precautions
7
z Ensure that there is no electromagnetic interference from
other electrical and
electronic equipments on the installation site.
z Do not refit the inverter unauthorized.
z
All the electric installation needs to be compliance with the national or local laws
and standards.
z The temperature of individual parts or the enclosure of the inverter–especia
lly
the heat sink may become hot in normal operation. There is a danger of burning.
Do not touch.
z Do not open the cover of inverters unauthorizedly. The electrical parts and
components inside the inverter are electrostatic. Take measurements to avoid
electrostatic discharge during relevant operation.
z The inverter must be reliably grounded.
z Ensure
that DC and AC side circuit breakers have been disconnected and wait
at least 5 minutes before wiring and checking.
Note:
Technical personnel who can perform installation, wiring, commissioning,
maintenance, troubleshooting and replacement
of the iMars series grid-tied solar
inverters
must meet the following requirements:
z Operators need professional training.
z Operators must read this manual completely and master the related safety
precautions.
z
Operators need to be familiar with the relevant safety regulations for electrical systems.
z
Operators need to be fully familiar with the composition and operating principle of the
entire grid-tied photovoltaic power generation system and related standards of the
countries/regions in which the project is located.
z Operators must wear personal protective equipment.
1.2.1 Delivery and installation
z Keep the package and unit complete, dry and c
lean during storage and delivery.
z P
lease remove and install the inverter with two or more people, because of the
inverter is heavy.
z Remove and install the inverter with appropriate
tools to ensure safe and normal
operation and avoid physical injury or death. The people also need m
echanical