Inxpect SBV System Series - Page 63

6.5.6 Change network parameters
In Settings > Network Parameters change the IP address, the netmask and the gateway of the control unit as
desired.
6.5.7 Change Modbus parameters
In Settings > Modbus Parameters enable/disable the Modbus communication and modify the listening port.
6.5.8 Change Fieldbus parameters
In Settings > Fieldbus Parameters change the F-addresses and the Fieldbus Endianness of the control unit.
6. Installation and use procedures
SBV System Series| Instruction manual v1.2 DEC 2021|SAF-UM-SBVBus-en-v1.2|© 2021 Inxpect SpA
63