51
Invoke HSM, then press [←]
Invokes Skip mode and skips from the current port to the rst
accessible port previous to it
Invoke HSM, then press [→]
Invokes Skip mode and skips from the current port to the next
accessible port
Invoke HSM, then press [b] Toggle hotkey beepers on or off
Invoke HSM, then press [X*] [Y*]
[Enter]
Switches KVM focus to the computer that is connected to Port X
in the 1st Level and Port Y in the 2nd Level
Note: If you only have a single level installation, simply ignore the
Y interval
Invoke HSM, then press [r] [Enter] Restore default settings (Administrator ONLY)
Invoke HSM, then press [a] [Enter]
or
Invoke HSM, then press [q] [Enter]
Invoke Auto Scan Mode
Note: Auto Scan can be paused and resume by pressing [p] or
by a single left-click on the mouse
*Note: X and Y are intervals from 1-8 (for GCS1808) and 1-16 (for GCS1716). When you enter, please
make sure you enter each of them as a 2 digit number, for example, you would need to type 01 for port 1.
To Next Page
Loading...
