Ioline FlexJet E - Serial Configuration

16
Ioline FlexJet E Quick Start Guide
Step 5: Level the Stand
1. Use the wrench to loosen the
9
/
16
-in lock nut on both of the right
leg leveling feet, turning them counter-clockwise. Place a level
across the top of the right stand leg. (See Figure)
2. Turn the
1
/
2
-in nut on each leveling foot counterclockwise to
lower the foot or clockwise to raise the foot until the leg is level.
Repeat this procedure for the left leg.
Placement of the level on the stand.
Check Stand Level
on legs rst
After legs are level,
check stand level at
Cross-member
Stand Leveling
Foot
3. Place a level on the cross-member. Repeat the adjustment
procedure as above except adjust both front and rear levelers
on each leg the same amount so that the legs stay level but the
cross-member moves. Adjust the threaded feet until the stand
is level on the cross-member.
4. Check the level of the legs again and make small adjustments
as necessary until the stand is level in both directions.
5. Tighten all of the
9
/
16
-in lock nuts on the levelers by turning
them clockwise.