Ioline FlexJet E - Assembly and Setup; Required Tools

Chapter 1
Assembly & Set-up
Assembly
This Quick Start Guide shows how to assemble and set up the Ioline
FlexJet E printer. Consult the FlexJet E User Guide on the CD-ROM
for more detailed information about installation and operation. Use
the provided Adobe
®
Acrobat
®
viewer to read and print the user
guide if necessary.
Unpacking the FlexJet E
Remove the printer, stand parts, and Accessory Kit from the box
and check the packing list. Always lift the printer with two people,
one person holding the bottom of the end covers. (See Step 3 for more
details.) Save all packing materials.
Required tools
n Hex (Allen) and 7/16-inch wrenches
and grease (included)
n 7/16, 1/2
,
and 9/16-inch open
ended or two adjustable wrenches
n A level
n Rubber headed mallet
n Phillips screw driver
Save all packing materials.
Note
i
The FlexJet E printer is
heavy and could cause
injury if it falls. A minimum
of two people are required
to safely unpack the printer and
attach it to the stand.
Caution