Regulatory Information
Product Name: Iomega Zip
®
100MB USB drive
Model Number: Z100USB
FCC (United States)
The computer equipment described in this guide generates and uses radio frequency
(RF) energy. If the equipment is not installed and operated in strict accordance with the
manufacturer’s instructions, interference to radio and television reception may result.
M Interference This equipment complies with Part 15 of the FCC Rules and its operation is
subject to the following conditions: (1) the equipment may not cause harmful interference,
and (2) the equipment must accept any interference received, including interference that
may cause undesired operation.M
Part 15, Class B, of the FCC Rules, is designed to provide reasonable protection against
radio and television interference in a residential installation. Although the equipment
has been tested and found to comply with allowed RF emission limits, as specified in the
above cited Rules, there is no guarantee that interference will not occur in a particular
situation. Interference can be determined by turning the equipment off and on while
monitoring radio or television reception. The user may be able to eliminate any
interference by implementing one or more of the following measures:
• Reorient the affected device and/or its receiving antenna.
• Increase the distance between the affected device and the computer equipment.
• Plug the computer and its peripherals into a different branch circuit from that used by
the affected device.
WARNING Changes or modifications to the electronics or enclosure of this product
must be expressly approved by Iomega; otherwise, the user’s authority to operate the
equipment may be voided by the FCC. M
Canadian Verification
This Class B digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulations (ICES-003, Class B).
CE (European Community)
The Zip 100MB USB drive conforms to the following European Directive(s) and
Standard(s): Application of Council Directives: 73/23/EEC, 89/336/EEC. Standards to
which Conformity is declared: EN60950, EN55022, EN50082-1. Importer’s Name:
Iomega Netherlands branch of Iomega International, S.A. Type of Equipment: Disk
Drive Subsystem.
Manufacturer/Responsible Party
Iomega Corporation
1821 West Iomega Way
Roy, UT 84067 U.S.A.
801-778-1000
To Next Page
Loading...
Need help?
General
