7
3.2. Set Dealer Information
From the main screen, touch MENU, on the bottom of the control, then Down (▼) button so
that the SERVICE icon is shown. The SERVICE icon allows you to upload your contact
information into the Ion System Control.
A170243I
• Format your contact information and logo (if applicable) using the PC/MAC Desktop
application available at www.IonComfort.com, and save it to a standard micro SD card. See
Dealer Contact Information Section for more information.
• Touch the SERVICE icon for about 10 seconds, touch DEALER CONTACT
INFORMATION, and then touch UPLOAD DEALER INFORMATION.
• Place the micro SD card into the micro SD card slot on the bottom of the Ion System Control
and follow the on screen prompts.
• More detailed information can be found at www.IonComfort.com.
4. Installation
4.1. Overview
This instruction covers installation of the Ion System Control (SYST0101CW) only. Physical
installation instructions for the indoor and outdoor equipment, and accessories are provided
with each unit.
Setup, commissioning, operation, and troubleshooting of the Ion System are covered in this
installation instruction at a high level. More detailed information may be available in the ICP
communicating HVAC equipment Installation Instructions. This is the guide to connecting the
system components and commissioning the system once all physical components are installed.
Special screen prompts and start-up capabilities are provided in the Ion System to simplify and
automate the initial commissioning of the system.
• Install the Ion System Control according to this instruction.
• Install indoor unit, outdoor unit, and accessories according to their instructions.
• Wire complete system according to this instruction.
To Next Page
Loading...
