2. Level the mount by adjusting the tripod legs to center the air bubble inside the spirit level. You may
slew the mount in AZI direction to check the leveling, during which the air bubble should stay inside
the small circle or stay at the same place.
3. Press MENU=>Settings =>Enter AA Mode to switch the hand controller to AA mode.
4. Slew the mount so that the telescope is pointing to Zenith and dovetail saddle is facing the EAST.
5. Press MENU=>Zero Position =>Set Zero Position. Press ENTER to confirm. This is the Zero
Position for the AA mode.
To Next Page
Loading...
