Ports on the iMate:
DC IN 12V: power input (5521,center positive) for iMate and 3X DC outputs
USB2.0 and USB2.0: for mount and accessories connection. A USB hub also can be connected
LAN: can be plugged into a network to obtain the date and time info
DC1, DC2, DC3: 12V power outputs (5521, center positive). DC3 is always on, with 3A maximum
current. DC1 and DC2 are programmable with 2A max. The default states are ON.
TF card slot (next to RESET): for microSD card
RESET: reset iMate
Connect Device to the iMate:
Connect the mount to one of the USB port on the iMate. Connect other accessories, such as cameras,
focuser, filter wheel, to other USB ports, directly or via a USB hub. Connect a 12V DC power supply to the
iMate DC IN port (5.5/2.1mm plug, center positive). Power on the mount and iMate and you are ready to go!
Since iMate uses KStars and INDI Lab, it can connect any device that has an INDI driver.
A USB hub can be connected to the iMate if more USB ports are needed.
To Next Page
Loading...
Need help?
General