IOtech 640 - Software Options for 600 Series Devices; eZ-Analyst; eZ-TOMAS; eZ-TOMAS Remote

IOtech 640 and 650 928291 Software Options 10-1
Software Options for 600 Series Devices 10
eZ-Analyst
Real- Time Vibration & Acoustic Analysis Software …… 10-2
eZ-TOMAS
On-line Rotating Machine Monitoring and Analysis Software …… 10-3
eZ-TOMAS Remote*
Remote monitor and control application …… 10-3
eZ- Balance
Rotating Machine, Field Balancing Software …… 10-4
eZ-NDT **
Non-Destructive Test Software …… 10-5
This chapter offers a glimpse of the eZ software packages that can be used with an IOtech 600 series device,
with exceptions as noted. The software is usually purchased when the hardware is ordered; but should your
acquisition needs change, additional software packages can be ordered at a later time.
Reference Notes:
For detailed information regarding software, refer to one or more of the following as
applicable.
 eZ-Analyst User’s Manual
 eZ-TOMAS and eZ-TOMAS Remote User’s Manual
 eZ-Balance User’s Manual
 eZ-NDT User’s Manual**
A PDF version of each is included on the installation CD and on our website.
* eZ-TOMAS Remote requires use of a licensed copy of eZ-TOMAS. For eZ-TOMAS Remote to operate,
the version numbers of the two applications (eZ-TOMAS and eZ-TOMAS Remote) must match.
** eZ-NDT does not support IOtech 652u.