EasyManua.ls Logo

iPA LIGHT RANGER MUTT 9101 - Specifications; Battery Requirements; Quick Start-Up Guide

iPA LIGHT RANGER MUTT 9101
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
SPECIFICATIONS
Input: 12V DC Battery (Use Battery Compartment)
Output: 10A @ 12V DC
Overload Protection: Auto-Resetting Thermal Circuit Breaker
Connection Type: #9101 - 7-Way Flat (Spade) Pin (6-Way Round and 4/5 Pin w/ Adapter)
#9102 - 7-Way Round Pin
Control Type: Manual Rotary Switch
Materials: ABS
Weight: 2 lbs. (empty)
BATTERY REQUIREMENTS
Battery Voltage: 12V DC
Battery Protection: 10A Auto-Resetting Thermal Circuit Breaker
Maximum Output to Trailer: 10 Amps
AUTO-RESETTING THERMAL CIRCUIT BREAKER
The thermally activated, internal auto-resetting thermal circuit breaker requires a 30-
second cooldown cycle. After this cycle, the illuminated power LED signies that the
unit is ready to test.
QUICK START-UP GUIDE
SELECT A BATTERY
The best battery to use is the YUASA YTX14 (12 Ah) or similar motorcycle type battery
with top mounted posts.
The battery must be 12-volts DC.
Maximum battery dimensions: L: 6" x W: 4" x H: 5.75".
Be sure to connect proper battery wires to the correct posts.
Once the battery is installed, testing can begin.
TAKING CARE OF YOUR BATTERY
Note: Every day a battery naturally loses its charge, little by little. Batteries are temperamental
and can be damaged easily. Using a battery very little and then recharging it will short cycle
the battery and hurt its overall life and output. Additionally, over discharging it (exceeding
80% total discharge) and then undercharging will permanently damage the battery as well.
It is not good to leave batteries in cold or hot weather. For every degree above or below
room temperature (72º F), a battery loses amp hours. Also, it is not good to allow batteries
to sit for weeks at a time without use or charging.
To get the most life out of your battery, it’s important to discharge about 30%-50% of its
total output, then provide a full recharge. When charging is complete, remove the battery
charger.
A 500mA battery charger has been provided with your purchase. Be sure to disconnect
the battery charger once it is fully charged. For any questions, please call 888-786-7899.

Related product manuals