EN
NOTE: using work program 2 reduces the
machine’s operating time.
INSTRUCTIONS FOR CORRECT
OPERATION:
After having followed all operations for starting
the machine, the machine is now ready to
work as a sweeper. To achieve the maximum
performance, follow the procedures in this
manual to avoid the risk of damaging the
machine.
Important:
• do not pick up wires, ropes, straps, water
or other liquids. If the work environment/
oor is damp, it is essential to turn o
the suction fan, as the lter could be
damaged.
• In the presence of bulky or particularly
light objects (paper, leaves, etc.), raise
the front of the machine by pushing on the
handle while picking up the waste.
Operate the lter shaker at the end of the job.
WARNING: this machine is not
intended for wet surface sweeping.
However, if you encounter a slightly
damp environment (moisture build-up
on the oor), the suction fan must be
switched o to prevent lter damage.
Machine damage due to wet debris
pick-up is not covered under warranty.
WARNING: if the sweeper remains
inactive for a period longer then
one month, disconnect the RED and
BLACK battery clips.
If it remains o for more than a week,
leave the sweeper connected to the
mains with the cable supplied (battery
charger power cable).
CLEANING THE DEBRIS BIN:
Before emptying the bin, make sure all
machine functions are turned o.
WARNING: WASTE DISPOSAL
MUST BE PERFORMED STRICTLY
FOLLOWING
THE LAWS IN FORCE.
To clean the rear debris bin, proceed as
follows:
• lift and turn the two rear bin locking
devices.
• hold the rear bin by the handle and pull it
out of the machine.
• empty the bin.
To replace the bin:
• insert the bin into the machine.
• turn and press the lock.
10
To Next Page
Loading...
