IPC Gansow 1280 - Finishing Work and Moving Machine

GB
Emptying the top unloading debris bin
! WARNING!
When emptying the bin, always wear a mask to protect the respiratory tract from the dust
which is always present during this operation.
! WARNING!
Before emptying the debris bin, operate the lter shaker for 30 seconds to clean the lter
! IMPORTANT!
When you open the bin, all functions are disabled on Battery and Dual Power versions, and
the engine is also switched off on the Dual Power version.
► Press and hold the bin movement enabling button (1, g. 29) then operate the bin up/down
switch (2, g. 29) to raise the bin to the required height.
► Pull the lever (g. 7) to rotate the bin and empty its contents.
► Turn the bin back to its horizontal position.
► Press and hold the bin movement enabling button (1, g. 29) then operate the bin up/down
switch (2, g. 29) to lower the bin again.
Finishing work
! IMPORTANT!
Shake the lter at the end of every work session.
When you nish work, switch the machine off at the main switch, lift the side brushes and main
brush and engage the parking brake.
Moving the machine when not in operation
Proceed as follows to move the machine.
► Raise the side brushes.
► Raise the main brush.
► Select the direction of travel.
► Press the accelerator pedal.
7
1
2
29
26