IPC Gansow 1280 - Changing the engine oil

GB
To avoid permanent damage to the batteries, do not run them down completely.
Charging procedure
Connect the battery charger connector to the battery wiring connector.
! WARNING!
In the case of gel batteries, use a charger specic for gel batteries only.
! WARNING!
Charge the batteries as instructed in the battery charger manual.
Disconnect the connectors at the end of charging.
Changing the engine oil
! WARNING!
On Dual power machines, change the engine oil when the “CHANGE ENGINE OIL” warning
appears on the display. On Petrol and Diesel machines, change the engine oil at the intervals
specied in the operation and maintenance manual provided by the engine manufacturer on
the basis of the hour counter on the machine’s dashboard. Always change engine oil with
the machine switched off and the engine cold.
Check that all machine functions are disabled, then lift the top cowling. Check that the engine is not
hot enough to cause burns then proceed as follows.
► Find the engine oil drain pipe and pass it through the hole in the engine compartment bot-
tom plate.
► Remove the oil level dipstick to facilitate drainage of the old oil.
► Position a suitable container under the drain pipe and unscrew the plug to let the old oil out.
► When the old oil has all drained out, t the plug back in the drain pipe and arrange the
pipe back inside the engine compartment, making sure that it does not interfere with any
moving parts.
► Add new oil through the dipstick hole in the quantity specied in the engine’s own manual.
► Once the right quantity of new oil has been added, t the oil level dipstick and check that
the level is correct.
► Close the top cowling.
33