GB
DISPLAY ALARMS
BRUSH MOTOR CUTOUT
TRIPPED
The brush motor has overheated.
BRAKE The parking brake is engaged or the drive motor has over-
heated.
STAND-BY The driver detection microswitch is not detecting an operator.
RELEASE ACCELERATOR Incorrect starting sequence. Release the accelerator pedal
when starting.
EEPROM 1 FAULT Replace the display board.
DRIVE CONTROL BOARD
CUTOUT TRIPPED
The drive control board has overheated.
ACCELERATOR FAULT There is a problem with the accelerator cable.
MAX. SPEED POTENTIOM-
ETER FAULT
There is a fault in the maximum speed potentiometer cabling.
UNDERVOLTAGE FAULT Check the batteries.
OVERVOLTAGE FAULT Check the batteries.
RELAY FAULT Replace the drive control board.
HPD Check the accelerator pedal. Switch the machine off and back
on with the accelerator released.
MOSFET FAULT Replace the drive control board.
EEPROM 2 FAULT Replace the drive control board.
37
To Next Page
Loading...
