supplied converter cable connects to the tester’s DC12V/1A OUTPUT and the other end connects to the
camera’s power input.
Power output function is mainly used in the camera field demonstration and testing, meanwhile, for
some camera installation sites, if there is no power outlet for the adapter to power the camera, the tester
can offer temporary power for it. But we do not suggest tester supply power for a long time.
Notice:
a. Don’t input any power into the “DC12/1A OUTPUT” port of the IP camera tester to avoid
destroy. man-made damage is not within the Company’s warranty
b. Don’t output this DC12V/1A power to DC12V/ IN port to avoid destroy. otherwise the tester will
damage, and man-made damage is not within the Company’s warranty.
c. The IPC tester power output is close to 1A, if the IP camera’s power is over 1A, the tester will
auto enter protection mode. Disconnect all the connections of the tester and then connect the
tester with power adaptor to resume the tester.
d. Make sure the tester has a sufficient charge otherwise the tester will not able to provide enough
output powe
To Next Page
Loading...