IPC Lavamatic 46 - Draining the Clean Water; Periods of Inactivity; Battery Maintenance and Charging

EN
Draining the clean water
DANGER
Use suitable personal protection devices.
Drain the water with the machine disconnected from the power supply
(cable model).
To empty the tank:
► position the machine near a drain;
► unscrew the cap (g. F, ref. 1);
► when the detergent tank is completely empty, screw the cap back on again (g. F, ref. 1).
i INFORMATION
The water and detergent solution can also be used to wash the dirty water tank.
PERIODS OF INACTIVITY
If the machine is not used for some time, remove the squeegee and brush (or pad drive board), wash them and
put them away in a dry place (preferably in a bag or wrapped in plastic lm) away from dust.
Make sure the tanks are completely empty and perfectly clean.
Disconnect the machine from the power supply (depending on the version, unplug it from the mains or disconnect
the fuse in the battery bridge).
Battery powered versions: charge the batteries completely before storing them. During long periods of inactivity,
remember to recharge the batteries periodically (at least once every two months) so that they are kept at the
maximum charge level.
WARNING!
If the batteries are not recharged periocially, they may su󰀨er irreparable damage.
BATTERY MAINTENANCE AND CHARGING
DANGER
Do not check the batteries by sparking.
The batteries give o󰀨 ammable fumes. Put out all res and hot embers before checking or topping up
the battery level.
Perform the operations described below in a ventilated area.
To avoid permanent damage to the batteries, do not run them down completely.
Remember that when the corresponding red light (g. C, ref. 2) ashes on the control panel, you must charge
the batteries.
Battery charger on board (OPTIONAL), recharging procedure
► connect the power cable from the on-board battery charger (g. G, ref. 1) to the mains power socket.
► Charge the batteries as described in the battery charger manual;
► on completion of charging, disconnect the cable of the on-board battery charger (g. G, ref. 1)
External battery charger, recharging procedure
► connect the battery charger cable to the machine (g. G, ref. 2).
► connect the charger power cable to the mains power socket.
► Charge the batteries as described in the battery charger manual;
► on completion of charging, disconnect the battery charger power cable and the cable connecting the
battery charger to the machine.
29