IPC Lavamatic 46 - Error Code Displayed

EN
The battery discharg-
es too fast during use,
even though it has been
charged correctly and
when tested with a hy-
drometer at the end of
recharging, it turned out
to be uniformly charged
(battery powered versions
only)
the battery is new and does not deliver 100% of
its expected capacity
the battery must be "run-in" by performing 20-30
charges and discharges to obtain maximum per-
formance
the machine is being used at maximum capac-
ity for continuous periods and the working time
is not su󰀩cient
if possible, use batteries with a higher capacity
or replace the batteries with others charged pre-
viously
the electrolyte has evaporated and does not
cover the plates completely
top up all elements with distilled water until the
plates are covered then recharge the battery
ERROR CODE DISPLAYED
Brush button LED (g. C, ref. 4), 2 quick ashes / pause / 2 quick ashes.Brush button LED (g. C, ref. 4), 2 quick ashes / pause / 2 quick ashes. Brush short circuit error.Brush short circuit error.
Contact customer service
Brush button LED (g. C, ref. 4), 1 ash / pause / 1 ashBrush button LED (g. C, ref. 4), 1 ash / pause / 1 ash.. Overcurrent errorOvercurrent error
Contact customer service
Suction button LED (g. C, ref. 5), 2 quick ashes / pause / 2 quick ashesSuction button LED (g. C, ref. 5), 2 quick ashes / pause / 2 quick ashes. Suction short circuit errorSuction short circuit error
Contact customer service
Suction button LED (g. C, ref. 5), 1 ash / pause / 1 ash.Suction button LED (g. C, ref. 5), 1 ash / pause / 1 ash. Overcurrent errorOvercurrent error
Contact customer service
Brush button LED (g. C, ref. 4) + suction button LED (g. C, ref. 5), synchronised ash Brush button LED (g. C, ref. 4) + suction button LED (g. C, ref. 5), synchronised ash
/ pause / synchronised ash./ pause / synchronised ash.
Electronic board temperature errorElectronic board temperature error
Contact customer service
Brush button LED (g. C, ref. 4), 4 quick ashes / pause / 4 quick ashes.Brush button LED (g. C, ref. 4), 4 quick ashes / pause / 4 quick ashes. Brush motor thermal overload.Brush motor thermal overload.
Contact customer service
Battery charge yellow LED (g. C, ref. 2), 7 quick ashes / pause / 7 quick ashes.Battery charge yellow LED (g. C, ref. 2), 7 quick ashes / pause / 7 quick ashes. Machine on with battery charger Machine on with battery charger
powered errorpowered error
Contact customer service
Battery charge yellow LED (g. C, ref. 2), 5 quick ashes / pause / 5 quick ashes.Battery charge yellow LED (g. C, ref. 2), 5 quick ashes / pause / 5 quick ashes. Excess battery voltage.Excess battery voltage.
Contact customer service
33