iPECS ES-3052GP - Page 339

C HAPTER 13 | Security Measures
Access Control Lists
– 339 –
ES-3052 Series
BINDING A PORT TO AN
ACCESS CONTROL
LIST
After configuring ACLs, use the Security > ACL (Configure Interface) page
to bind the ports that need to filter traffic to the appropriate ACLs. You can
assign one IP access list and one MAC access list to any port.
CLI REFERENCES
◆ "ip access-group" on page 729
◆ "show ip access-group" on page 729
◆ "mac access-group" on page 740
◆ "show mac access-group" on page 741
◆ "Time Range" on page 583
COMMAND USAGE
◆ This switch supports ACLs for ingress filtering only.
◆ You only bind one ACL to any port for ingress filtering.
PARAMETERS
These parameters are displayed in the web interface:
◆ Type – Selects the type of ACLs to bind to a port.
◆ Port – Fixed port or SFP module. (Range: 1-52)
◆ ACL – ACL used for ingress packets.
◆ Time Range – Name of a time range.