Ipevo IW2 - Troubleshooting: Interference and Accuracy; Interference and Connection Stability; Accuracy and Calibration After Changes

24
FAQ (cont’d)
1. Place the Sensor Cam within 1.6 ft (50cm) of your computer.
2. Power up the Sensor Cam. The Sensor Cam LED indicator should show a
blinking Orange.
Note: Do NOT plug the Wireless Receiver into your computer’s USB port during this step.
3. Press the Pairing Button for 3 seconds to enter Pairing Mode. The Sensor
Cam LED indicator should blink alternately between Orange and Green.
4. Plug the Wireless Receiver into your computer’s USB port. The Sensor Cam
LED indicator will blink Green three times before changing to a solid Green,
which lets you know the pairing is successful.