iPower 1492006 REV00 - User Manual

Questions and Answers

T
Taylor ShahAug 15, 2025
What to do if my iPower Portable Generator has no AC output?
- J
  Jill BrownAug 15, 2025
  If your iPower Portable Generator's engine runs but there's no AC output, it could be due to several reasons. First, check the AC load and reset the circuit breaker if it's open. Also, inspect for poor connections or defective cord sets and repair if necessary. Ensure the connected device is in good condition by testing with another device. If your generator has a GFCI outlet, check if it's open and press the reset button after correcting any ground faults.
L
Lisa JacksonAug 19, 2025
Why does my iPower Portable Generator shut down while running?
- C
  Christine WatsonAug 19, 2025
  If your iPower Portable Generator shuts down while running, consider these potential causes: Ensure the fuel tank is full. Clean or replace the air cleaner. Check the oil level and fill to the correct level or place the generator on a level surface. If the generator shut off due to CO accumulation and a blinking red indicator light, follow all safety instructions on the CO Action Label. If you are using gasoline or propane/LPG, make sure that the fuel tank is full with gasoline or replace LPG cylinder/ check propane/LPG supply.
C
Charles LawsonAug 25, 2025
How to troubleshoot power loss in my iPower Portable Generator?
- S
  Scott SmallAug 26, 2025
  If your iPower Portable Generator lacks power, consider these possible causes: Reduce the load if it's too high. Replace the air filter if it's dirty. Clean or replace the fuel filter if it's clogged or dirty. Clean or replace the spark arrester screen if it's clogged or dirty. Drain the gas tank and carburetor and fill with fresh fuel if the fuel is bad.
J
Joseph BryantAug 30, 2025
What to do if my iPower Portable Generator bogs down under load?
- C
  Christine ZimmermanAug 30, 2025
  If your iPower Portable Generator runs fine without a load but bogs down when you connect something, there are a few things to check. First, disconnect any electrical load that might have a short circuit. Reduce the load if the generator is overloaded. Clean or replace the fuel filter if it's clogged or dirty. Connect another device that is in good condition.
A
anthonymoralesSep 3, 2025
Why does my iPower 1492006 REV00 Portable Generator engine hunt or falter?
- M
  Melissa WilliamsSep 3, 2025
  If your iPower Portable Generator engine hunts or falters, try setting the choke to the halfway position until the engine runs smoothly. Replace the fuel filter if it is clogged or dirty.
C
Craig LyonsNov 9, 2025
Why won't my iPower 1492006 REV00 Portable Generator start?
- S
  sstevensNov 9, 2025
  If your iPower Portable Generator doesn't start, runs poorly, or shuts down, there are several possible causes: * Ensure the engine switch is in the ON (l) position and the fuel valve is also in the ON (l) position. * Check the oil level and fill the crankcase to the correct level, or place the generator on a level surface. * Clean or replace the air filter. * Make sure the fuel tank is full and the fuel isn't stale; if it is, drain the tank and carburetor and refill with fresh fuel. * Verify the spark plug wire is connected, and replace the spark plug if it's bad. * Drain the gas tank and carburetor and fill with fresh fuel to remove any water. * If the engine is flooded, wait 5 minutes before attempting to restart it. * If the generator shut off due to CO accumulation an...