All rights reserved and shall not be copied and distributed in any form without written permission
11th Guiyang Street, YEDA,
Yantai 264006, P. R. China
400-998-3088
In the zeroing interface, there is a white dot that represents the original position of
the reticle before calibration.
After zeroing, the center of all reticles will be changed accordingly.
J. Blind Pixel Calibration
In the advanced menu, press the Power/C button to select the blind pixel
calibration item and press the M button to enter the calibration interface as shown
in figure 5.
In the blind pixel calibration interface, press P and C button to move the reticle
up/down or left/right. Press M button to switch up/down or left/right.
After selecting the blind pixel, long press P and C button to calibration, and press
the same button again for cancelation. The number of the blind pixels calibrated is
displayed on the bottom of the screen.
Repeat the above process till all blind pixels are calibrated, and long- press the M
button to save and exit.
Fig.5 Blind pixel calibration interface
K. Reset to Default
In the advanced menu, press Power/C button to select the default resetting item,
then press M button to enter the resetting interface as shown in figure 6.
Then press the P and C button to switch the option. The “√” is to reset to the
To Next Page
Loading...
