Quick User Guide – IRIScan
TM
Mouse Wifi
4. Hardware Overview
1. Left-click button
2. Mouse wheel / Click button
3. Right-click button
4. Battery and Wifi indicator led
5. Scan button
6. On/Off button
7. Scan surface
Remove plastic before first use.
8. Mouse label
9. Micro USB port
10. Scan sensors
Before you get started:
Charge the IRIScan
TM
Mouse Wifi for 30 minutes. To do so, plug it into a computer using the provided USB
cable and power on the computer, or plug the IRIScan
TM
Mouse Wifi into a power outlet.
The battery life when using the scan function is about 48 hours.
To check the battery status, press the Scan button and watch the battery led:
When the led blinks blue once, the battery is fully charged.
When the led blinks red twice, the battery has low power.
When the led blinks red once, the battery is almost flat and you need to recharge it.
Note however that even when the battery is flat you can still use the IRIScan
TM
Mouse Wifi as a regular
wireless mouse.
Attention: the USB cable is only used to charge the battery, not to use the mouse. In order to use the
mouse and its scan function you need to plug in the dongle.
To Next Page
Loading...
Need help?
General
