Page 3 of 13
BB074Installation Guide
©Copyright 2021 Ironman 4x4 Pty Ltd. No part of this publication may be reproduced or replicated without the prior written consent of Ironman 4x4 Pty Ltd
1. Confrim bull bar application is
suitable for your vehicle make,
model and year.
2. Unwrap the bull bar and ensure
the overriders and light assemblies
are tight in the bull bar before
installation.
3. Remove all clips and under trays
from lower section of bumper bar.
Retain clips for re-fitment later.
4. Disconnect indicator and fog light
wiring from bumper.
5. Mask sections of bumper to be cut,
place cutting template in position
and mark cut lines on bumper.
To Next Page
Loading...
