Page 2 of 16
BBC067 / BBCD067 / BBA067 / BBT067-NLInstallation Guide
©Copyright 2018 Ironman 4x4 Pty Ltd. No part of this publication may be reproduced or replicated without the prior written consent of Ironman 4x4 Pty Ltd
1. Before installation check bull bar
application is compatible with your
vehicle.
2. Disconnect any bumper lights,
sensors and cameras. Remove
factory bumper bar, grill assembly
and factory protection plate from
under radiator.
Remove washer bottle, filler neck
and bumper support panel.
3. Temporarily mount bull bar cradle
to front cross member using 4
captive nuts. Ensure bracket is
centralised.
4. Mark 8 holes to be drilled through
cross member and remove bull bar
cradle.
To Next Page
Loading...
