Page 2 of 25
BBC / BBCD / BBP110 Installation Guide
©Copyright 2023 Ironman 4x4 Pty Ltd. No part of this publication may be reproduced or replicated without the prior written consent of Ironman 4x4 Pty Ltd
Document Number: BB110/241123
Pre-Installation Procedures
SAFETY WARNING
• It is always good practice to disconnect the battery while working on 12 Volt systems.
- Please check the owner’s manual for vehicle-specific requirements as some models may need
battery backup.
• Auto electrical work should be carried out by a competent person. Vehicle wire colours are listed as a
guide only and may vary on some makes and models.
• The function of each wire should be checked before any connections are made.
All wires tapped into should be soldered and then insulated with electrical tape or heat shrink.
• Grounding/Earth points must always be connected to the factory grounding points, not to the battery
negative terminal. See owner’s manual.
• Using only a LED test light, test all electrical components of the vehicle before and after wiring.
This is to ensure everything works correctly.
• Ironman 4x4 does not recommend the installation of large or light-coloured antennas or aerials to the
front of a bull bar as this may cause the lane departure system to malfunction.
NOTE
• Only a competent person should perform accessory installations. It is the responsibility of this person
to ensure correct fitment.
• Whilst working on this vehicle, always use appropriate safety equipment.
• Read and understand instructions fully before commencing fitment.
• Check the hardware supplied against the contents list on the following pages.
• Do not use this product for any vehicle make or model other than specified in these instructions.
• This product and or hardware must not be modified in any way. Do not remove labels from this product.
• Recording the batch number on the customer’s job card is good practice for future reference,
or complete the information below and file with customer job card.
CARE INSTRUCTIONS
• To maintain the finish of the product, wash regularly using a PH neutral car wash, hose off and
chamois dry.
• Do not use acidic or alkaline cleaners.
• Plastic components can be maintained with a silicone spray or similar (non-acidic or alkaline based).
CUSTOMER INFORMATION
Customer Name: Date:
Contact:
Part Number: Batch Number:
(Located on label behind bull bar wing)
#
To Next Page
Loading...
