Page 3 of 25
BBC / BBCD / BBP110Installation Guide
©Copyright 2023 Ironman 4x4 Pty Ltd. No part of this publication may be reproduced or replicated without the prior written consent of Ironman 4x4 Pty Ltd
Document Number: BB110/241123
• Ironman 4x4 recovery points are FEA tested during design and destruction tested during development
to establish the Working Load Limits (WLL).
• Ironman 4x4 recovery points have been designed as a matching pair, supplied as right and left sides
for vehicle-specific fitment.
• Ironman 4x4 includes specific mounting hardware to ensure correct fitment to your 4WD.
The correct fitment of these components is critical for your safety.
• Do not use this recovery point for any other vehicle make or model other than the one intended and
specified by Ironman 4x4.
• Do not alter or modify the recovery point in any way. Doing so may compromise the strength and
integrity of the recovery point.
• Ensure all bolts are tightened to the specified torque.
• Do not remove warning labels from recovery points. (Some recovery points require the warning labels
to be installed, these are supplied and must be installed).
• It is advised to use an equalising or bridle strap. Failure to do so correctly can result in recovery point
fatigue or bending and void your warranty.
• Never use a single recovery point combined with a side load pull.
• Recovery Points are designed for a straight-line pull, by pulling on an angle or sideways pull may
result in a reduction of the WLL.
NOTE
• This product has been tested for airbag compatibility; therefore, the mounting system MUST NOT
be modified.
• Fitting instructions are correct at the time of publication date and Ironman 4x4 cannot be held
responsible for any vehicle changes from the manufacturer. It is the responsibility of the installer
to ensure correct fitment.
Page 3 of 25
Installation Guide
Warning
To Next Page
