iRoom iDock - Product Operating Instructions; Restoring Default Configuration and Password; Basic Network Configuration Steps

Page 8 Page 9
English
Restoring the Default Conguration and Password
You can restore factory defaults in two ways:
1. Use the "restore to factory settings" function of the iRoom‘s iDock iOS-App
• Access-Code is required
2. Use the Default Reset DIP Switch#1 on the rear panel of the iDock:
• Power off your iRoom‘s iDock
• Switch DIP#1 to ON
• Power on your iRoom‘s iDock and wait until LED is ashing quickly.
• Power off your iRoom‘s iDock
• Switch DIP#1 to OFF
• Restore process nished.
To locate the DIP Switch please refer to chapter "Main Board Feature
Overview".
Operating Instructions
Operation:
• Touch & release the sensor, to open/close the iRoom‘s iDock tray.
• The iPad tray remains in open position for 10 seconds, than closes
automatically.
• If there is a power loss, the iPad tray opens automatically
All above mentioned and many more settings can be modied via our iOS App
"iRoom‘s iDock". Detailed descriptions can be found within the iOS App Help
Section.
If you have purchased a TouchCode or KeyCard model, please refer to the
specic descriptions included with the product.
Basic Network Conguration
To congure iRoom‘s iDock, access it via a docked iPad using the free iOS App
"iRoom‘s iDock".
Default IP : DHCP / 192.168.0.100
Default Access-Code : iBezel