Semi-Automatic operation enables a selected Program watering
cycle to be started manually. Once running, the manual advance
feature enables you to step through the programmed station
sequence.
1. Place the Function switch in the Run position.
2. Turn the Dial to the Current Time position.
3. Place the Program switch to select A, B or C.
4. Press the Semi-Auto button to start the watering cycle.
Note: Once started, the station sequence can be manually
advanced by pressing the Manual button.
Note: The Manual Advance feature applies to all Automatic,
Semi-Automatic and Station Test watering operations for the
selected Program.
Note: To terminate watering operations, place the Function
switch momentarily in the OFF position.
Semi-Automatic Operation
O Manual Operations
30
66767_RainDial 0428A 3/28/07 2:25 PM Page 30
To Next Page
